Mixing Procedure

• Add Bulletproof Si to your water first and mix well. Wait five minutes, then add Micro. Stir well and wait five more minutes before continuing with the remainder of the feed chart sequence.
• If using Plant Amp with our advanced recipe, check the pH and make any necessary adjustments prior to addition. Plant Amp contains organic acids, which cause a temporary low pH reading. Do not adjust pH up after adding Plant Amp, the pH will rise naturally as the plant uptakes the chelated calcium in one or two days. Normal pH reading when using Cutting Edge Solutions products, depending upon water sources, ranges from 4.5 pH to 6.5 pH.
• These values reflect a maximum dosage, customer may use less concentration if desired. Be sure to keep measurements balanced, simply use more pure water to dilute nutrient concentration.
• Deep water culture and R.D.W.C. systems should use the recirculating feedchart, run at 33% - 50% strength of the maximum dose.